DSL-2750U Wireless ADSL2+ Router with 3G/LTE/Ethernet WAN Support
and USB Port
User Manual
Configuring via Web-based Interface
Creating LTE WAN Connection
!
For the USB modem Megafon M100-1, please reboot the router after creating the WAN
connection.
If the PIN code check is enabled for the SIM card inserted into your USB modem, then prior to
creating an LTE WAN connection, go to the USB Modem menu and enter the PIN code
9
on the
page displayed (see the USB Modem section, page 152). Then on the connection creation page, go
to the All Settings tab, select the relevant value from the Connection Type drop-down list, and
specify the needed values.
Figure 83. The page for creating a new LTE connection. Selecting a connection type.
Parameter Description
Enable connection
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
Connection name
Available for the advanced mode only.
A name for the connection for easier identification.
9 For some models of LTE USB modems it is required to disable the PIN code check on the SIM card prior to
connecting the USB modem to the router.
Page 106 of 210
To Next Page
Loading...
Need help?
Data Transfer Rates
