D-Link DSL-2750U User Manual

DSL-2750U Wireless ADSL2+ Router with 3G/LTE/Ethernet WAN Support
and USB Port
User Manual
Configuring via Web-based Interface
Creating Bridge WAN Connection
On the connection creation page, go to the All Settings tab. Then select the relevant value from
the Connection Type drop-down list and specify the needed values.
Figure 75. The page for creating a new Bridge connection. Selecting a connection type.
Parameter Description
Interface
A physical interface to which the new connection will be assigned.
In order to create an Ethernet WAN connection, select the value
corresponding to the LAN port specified as the WAN port.
In order to create an ADSL WAN connection, select the value
corresponding to the existing interface or the Add new ATM PVC
value for creating a new interface at the physical layer.
Enable connection
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
Connection name
Available for the advanced mode only.
A name for the connection for easier identification.
Page 97 of 210

D-Link DSL-2750U Specifications

Data Transfer Rates

G.dmt full rate downstream	up to 8 Mbps
G.dmt full rate upstream	up to 1 Mbps
G.lite ADSL downstream	up to 1.5 Mbps
G.lite ADSL upstream	up to 512 Kbps
G.dmt.bis full rate downstream	up to 12 Mbps
G.dmt.bis full rate upstream	up to 12 Mbps
ADSL full rate downstream	up to 24 Mbps
ADSL full rate upstream	up to 1 Mbps

Media Interface

ADSL interface connector type	RJ-11
ADSL interface cable type	24/26 AWG twisted pair telephone line
LAN interface port type	RJ-45
LAN interface standard	10/100BASE-T Ethernet