D-Link N300 User Manual

DIR-620S Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
To change the web-based interface language, select the needed value from the Language drop-
down list.
The following buttons are also available on the page:
Control Description
Factory
Click the button to restore the factory default settings. Also you can
restore the factory defaults via the hardware RESET button (see the
Back and Bottom Panels section, page 15).
Backup
Click the button to save the configuration (all settings of the router)
to your PC. The configuration backup will be stored in the
download location of your web browser.
Restore
Click the button and follow the dialog box appeared to select a
previously saved configuration file (all settings of the router)
located on your PC and upload it.
Save
Click the button to save settings to the non-volatile memory.
The router saves changed settings automatically. If changed settings
have not been saved automatically, a notification is displayed in the
top right part of the page.
Reboot
Click the button to reboot the device. All unsaved changes will be
lost after the device's reboot.
In the Idle time field specify a period of inactivity (in minutes) after which the router completes
the session of the interface. By default, the value 5 is specified. Then click the SAVE button.
To configure automatic reboot of the device on a schedule, in the Automatic Reboot section,
move the Enable switch to the right and specify the time period for the device's reboot (in seconds)
in the Period field. Click the SAVE button.
To disable automatic reboot of the device on a schedule, in the Automatic Reboot section, move
the Enable switch to the left and click the SAVE button.
Page 213 of 236

D-Link N300 Specifications

General

Wireless Speed	300 Mbps
Frequency Band	2.4 GHz
Wireless Standards	IEEE 802.11n/g/b
Antenna Type	Internal
Ports	1 x 10/100 Mbps Ethernet Port
Security	WPA, WPA2
Product Type	Range Extender