24
DCS-900W Configuration (continued)
Advanced > System
LED Control:
The LED control allows you to set up the LED illumination as desired. This feature
provides flexibility when surveillance activity is ON.There are three options as follows:
Normal
Power -LED indicator is steady ON.
LAN- When LAN activity is present, the LED indicator will flash steadily
ON.
OFF
Power - LED indicator is off.
LAN – LED indicator is off.
Dummy
Power - LED indicator is steady ON.
LAN - LED indicator is ON with random flashing.
HEX input format
HEX format interprets each pair of characters as an eight-bit value in hexadecimal (base
16) notation. Only the digits 0 through 9 and the letters A through F (in upper or lower
case) are valid. To set up a 64-bit WEP key, input 10 numbers in HEX format, for
example, ‘3132333435’, this is the same with the ASCII input ‘12345’. To set up a 128-
bit WEP key, input 26 numbers in HEX format, for example,
‘31323334353637383930313233’, this is the same with the ASCII input ‘1234567890123’.
This results in bit counts of 40 and 104, respectively; the Internet Camera will
automatically pad your input to a bit count of 64 or 128.
In the Confirm WEP Key field, input the same characters that were inputted in the
Encryption Code field.
Make sure the Encryption Code matches the Access Point’s encryption code when the
Internet Camera is connected in Infrastructure mode. Your PC/Notebook’s encryption
code also needs to match the encryption code used by the Internet Camera in either
Infrastructure mode or Ad-hoc mode.
By default, an Encryption key is not assigned to the DCS-1000W. Therefore, to secure
the wireless transmission be sure to enable the Encryption Key by entering the relevant
data
.
Note:
Be sure to carefully input and document the Encryption Code; input errors will cause
the communication link to fail.
To Next Page
Loading...
Need help?
General