D-Link xStack DES-3200 Series User Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
32
4
enable qinq
This
command is used to enable the Q-in-Q mode.
Purpose
enabl
e qinq
Syntax
This
command is used to enable Q-in-Q mode.
Description
When Q-in-Q is enabled, all network port roles will be NNI port and their
outer TPID will be set to 88a8. All existing static VLANs will run as SP-
VLAN. All dynamically learned L2 address will be cleared. GVRP and
STP need to be disabled manually.
If you need to run GVRP on the Switch, firstly enable GVRP manually.
The default setting of Q-in-Q is disabled
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable Q-in-Q:
DES-3200-28:4#enable qinq
Command: enable qinq
Success.
DES-3200-28:4#
disable qinq
This
command is used to disable Q-in-Q mode.
Purpose
disa
ble qinq
Syntax
This
command is used to disable Q-in-Q mode.
Description
All dynamically learned L2 address will be cleared. All dynamically
registered VLAN entries will be cleared, GVRP will be disabled.
If you need to run GVRP on the Switch, firstly enable GVRP manually. All
existing SP-VLANs will run as static 1Q VLANs. The default setting of
Q-in-Q is disabled.
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To disable Q-in-Q:
DES-3200-28:4#disable qinq
Command: disable qinq
Success.
DES-3200-28:4#

D-Link xStack DES-3200 Series Specifications

General

Brand	D-Link
Model	xStack DES-3200 Series
Category	Network Router
Language	English