D-Link xStack DES-3200 Series User Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
52
4
APPENDIX C - RADIUS ATTRIBUTES ASSIGNMENT
The RADIUS Attributes Assignment on the DES-3200 is used in the following modules: 802.1X (Port-based and Host-based),
and MAC-based Access Control.
The description that follows explains the following RADIUS Attributes Assignment types:
 Ingress/Egress Bandwidth
 802.1p Default Priority
 VLAN
 ACL
To assign Ingress/Egress bandwidth by RADIUS Server, the proper parameters should be configured on the RADIUS Server.
The tables below show the parameters for bandwidth.
The parameters of the Vendor-Specific attributes are:
Vendor-Specific Attribute Description Value Usage
Vendor-ID Defines the vendor. 171 (DLINK) Required
Vendor-Type Defines the attribute. 2 (for ingress
bandwidth)
Required
3 (for egress
bandwidth)
Attribute-Specific Field Used to assign the bandwidth
of a port.
Unit (Kbits) Required
If the user has configured the bandwidth attribute of the RADIUS server (for example, ingress bandwidth 1000Kbps) and the
802.1X authentication is successful, the device will assign the bandwidth (according to the RADIUS server) to the port. However,
if the user does not configure the bandwidth attribute and authenticates successfully, the device will not assign any bandwidth to
the port. If the bandwidth attribute is configured on the RADIUS server with a value of “0” or more, than the effective bandwidth
(100Mbps on an Ethernet port or 1Gbps on a Gigabit port) of the port will be set to no_limited.

D-Link xStack DES-3200 Series Specifications

General

Brand	D-Link
Model	xStack DES-3200 Series
Category	Network Router
Language	English