D-Link xtreme n duo dap-1522 User Manual

31D-Link DAP-1522 User Manual
Section 3 - Configuration
Enable DHCP
Server:
IP Address From/
To:
Default Subnet
Mask:
Default Gateway:
Default Wins:
Default DNS:
DHCP Lease
Time:
DHCP Client List:
Check to enable the DHCP Server on the access
point.
Enter the IP address range to assign to the
clients on your network.
Note: If you statically (manually) assign IP
addresses to your computers or devices, make
sure the IP addresses are outside of this range
or you may have an IP conflict.
Enter the subnet mask.
Enter the default gateway IP address.
Enter the WINS server IP address.
Enter the DNS server IP address.
Enter the DHCP lease time (in minutes).
Clients on your network that are assigned IP
addresses will be displayed here.
DHCP Server
DHCP stands for Dynamic Host Control Protocol. The DAP-1522 has a built-in DHCP server. The DHCP Server will
automatically assign an IP address to the computers on the LAN/private network. Be sure to set your computers to be
DHCP clients by setting their TCP/IP settings to “Obtain an IP Address Automatically.” When you turn your computers on,
they will automatically load the proper TCP/IP settings provided by the DAP-1522. The DHCP Server will automatically
allocate an unused IP address from the IP address pool to the requesting computer.

D-Link xtreme n duo dap-1522 Specifications

Physical Interfaces

gigabit LAN ports	4
push-button for Wi-Fi Protected Setup	1
three-way switch	1

Weight and Dimensions

dimensions	4.4” x 5.7” x 1.3”
packaging dimensions	8.2” x 10.8” x 2.7”
weight	0.5 lbs
packaging weight	1.7 lbs