D-Link xtreme n duo dap-1522 User Manual

36D-Link DAP-1522 User Manual
Section 3 - Configuration
Add Traffic Manager Rule
In Traffic Manager Rule enter settings for each user of your network, using adequate IP (Client IP) or MAC address (Client
MAC). Set appropriate Ethernet to Wireless and Wireless to Ethernet speeds for the traffic you want to regulate.
Enter a name for your new rule.
The IP address assigned to the client.
By assigning MAC addresses to the set of traffic manager rules, specific rules can be defined for individual devices.
Represents the available bandwidth for client data to be forwarded from Ethernet to wireless, the suggested range is 800 ~
96000kbits/sec.
Represents the available bandwidth for client data to be forwarded from wireless to Ethernet, the suggested range is 800 ~
96000kbits/sec.
Note: Normally the wireless connection transmits application data packets based on the wireless to Ethernet speed and
Ethernet to wireless speed. Users can treat the two speeds as system transmission bandwidth, where all applications will
share the whole system bandwidth based on assigned priorities. Note that the maximum amount of bandwidth that can be
used is the same as the set value of both speeds.
Name:
Client IP
(optional):
Client MAC
(optional) :
Ethernet to
Wireless:
Wireless to
Ethernet:

D-Link xtreme n duo dap-1522 Specifications

Physical Interfaces

gigabit LAN ports	4
push-button for Wi-Fi Protected Setup	1
three-way switch	1

Weight and Dimensions

dimensions	4.4” x 5.7” x 1.3”
packaging dimensions	8.2” x 10.8” x 2.7”
weight	0.5 lbs
packaging weight	1.7 lbs