36
When the engine oil is contaminated, the life of engine
will be remarkably shortened. Keep the proper engine
oil level, kind and replacing period.
●
Place the vehicle on a flat surface, and idle(warm up)
the engine 2~3 minutes.
●
Stop the engine, separate the engine oil level gauge,
place a vessel under the engine, remove the oil drain
bolt to drain the oil
●
Remove the tappet adjusting hole cap, and clean the
oil filter screen.
●
Check the seal rubber of oil filter screen, the O-ring.
●
Install the oil drain bolt, assemble the oil filter screen,
spring, tappet adjusting hole cap.
●
At replacing the oil, add the engine oil by opening the
oil level gauge in RH. Crank case cover.
●
At adding the oil, check the oil level gauge and re-fill it
near to the upper level.
WWHHEENN CCHHAANNGGIINNGG OOIILL :: 11..11 LL
TTOOTTAALL CCAAPPAACCIITTYY OOFF TTHHEE OOIILL :: 11..33 LL
SPECIFIED GENUINE OIL
Don’t fill the low grade oil. Using it can cause damage
to engine, and can’t receive the warranty.
UUssee oonnllyy tthhee ggeennuuiinnee ooiill.. GGeennuuiinnee ooiill ::
MMOOTTIIXX 44 ooiill
SSLL ggrraaddee((SSAAEE :: 1100WW//4400))
CHANGING ENGINE OIL
OIL FILTER
SCREEN
OIL FILTER
SCREEN
SPRING
TAPPET
ADJUSTING
HOLE CAP
OIL DRAIN BOLT
●
When changing the engine oil immediately after
stopping the engine, be careful not to be burnt the
heated oil.
●
Don’t fill the low grade oil. Using it can cause the
damage to engine and parts. If the engine is stuck
while traveling due to this, it may lead death or
serious injury. Use only the genuine oil.
●
Do not pour the 2 cycle engine oil. Using it can
cause serious damage to engine. If the engine is
stuck while traveling due to this, it may lead death
or serious injury.
●
If the tire is stained with oil while or after refueling,
the vehicle may slip while traveling to cause roll
over,
●
Do not discard the engine oil other than specified
place. It will bring environmental contamination,
and be brought under the law.
●
If changing the oil by loosing the oil drain bolt,
disassemble the tappet adjusting hole cap surely
and clean the oil filter screen.
●
Right after the engine stopped, because the engine
oil already being heated, be careful about to be
burnt at replacing the new engine oil.
●
When refueling, make sure not to enter the dirt or
dirty material into oil pouring port.
●
If the oil overflows, wipe it cleanly.
To Next Page
Loading...
Need help?
General
