EasyManuals Logo
Home>DAELIM>Scooter>Q2

DAELIM Q2 User Manual

DAELIM Q2
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
41
CAUTION
If the air cleaner element is
inadequately assembled, dust and
other waste materials can directly
enter the engine. This results in
increased cylinder wear and reduced
power, and reduced durability of the
engine.
When washing the vehicle, be careful
not to allow water to get into the air
cleaner. Difficulties in starting the
engine may result if this happens.
If the engine start is failed during
rain or after driving across water
pool, check to see if the water is
infiltrated in the air cleaner and clean
it.
Do not drive in the flooded area. If
the water enters the air cleaner or
engine, the vehicle may be subjected
to the rear-end collision due to the
power failure.
<REMOVAL>
Loosen the 6 screws assembling the air
cleaner case cover and remove the tube
clip and air cleaner case cover.
Disassemble the air cleaner element
and inspect it.
If the air cleaner element is excessively
dirty or damaged, replace it with the
new one.
Assemble correctly air cleaner element
and seal, then assemble air cleaner
cover.
AIR CLEANER ELEMENT INSPECTION
AIR CLEANER ELEMENT
AIR CLEANER COVER
NORMAL
CUT
CAUTION
At replacing fuse, OFF the main switch.
If the main switch is ON, the fire accident
may occur because of short circuit.
Check whether the fuse assembled to
the holder moves or not at assembling it.
If the fuse assembly is loose,
unexpected accident may occur.
Do not use the over-capacity fuse.
Because this may cause the overheating
of wires and damage, be sure to never use.
When installing electric parts(lights,
meters, etc), because there are different
fuses for various vehicles, this may
cause the fuse cut or battery discharge.
At washing the vehicle, be careful not
to wash strongly around the fuse holder.
In order to remove the fuse, do not use
the drivers or metal materials. That
may damage the electric parts or
equipment due to short circuit, etc.
After replacing the fuse, if the fuse
continuously cut, this means other
overload to electric system. Then visit
to the designated service shop.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DAELIM Q2 and is the answer not in the manual?

DAELIM Q2 Specifications

General IconGeneral
BrandDAELIM
ModelQ2
CategoryScooter
LanguageEnglish

Related product manuals