8
TRIPOD INSTALLATIONS
DAHUA 50230 OR 42212 CAMERA SETUP
Your system may have one or more Dahua 50230 30x zoom or 42212 12x zoom
cameras. If so, then perform the following steps.
Collect the following components:
1. Dahua camera on junction box with tripod mount and Ethernet connector.
2. CST/Berger surveyor tripod
3. Planet POE171 single-output, 60W injector or a FSD-504HP four-output, 60W
PoE power injector with power supply and line cord as shown below. Note:
These cameras cannot be used with a POE164 Injector due to its lower, 30W
output power. The POE164 may be used with the N51BD22 camera.
4. Ethernet 6’ cable
5. Ethernet 100’, 196’ or 300’ all-weather cables. Note: The maximum length for
a camera to injector cable is 100 meters or 328 feet.
6. Optional castor cups, set of 4
Setup Procedure:
1. Open the tripod in the selected location. Remove the protective cap on the tripod
threads.
2. Place the camera assembly on top of the tripod and using the knob under the
tripod, screw the tripod treads into the bottom of the camera assembly. The
assembly does not have to be precisely located at the center of the top of the
tripod.
To Next Page
Loading...
Need help?
General
