16
Initialize the devices Figure 4-6
Tap One-key Config to finish the configuration of the VTO and VTH, as well as the SIP server. Step 9
The status bar will suggest whether your configuration is successful.
Manual Configuration 4.3
You could manually configure the parameters you want to modify.
4.3.1 Configuring Network Parameters
You can choose to connect the VTH to the network either through WLAN or LAN.
4.3.1.1 WLAN
Tap and hold Setting for about 3 seconds, and enter the password that you set for the VTH. Step 1
Tap Network > WLAN. Step 2
Enable to see all the usable networks. Step 3
Before connecting to a Wi-Fi network, do either of the following first. Step 4
Tap WireLessIP, enter local IP, subnet mask and gateway that you plan for the VTH,
and then tap OK.
Tap WireLessIP, tap to enable the DHCP function to obtain IP information
automatically.
To enable the DHCP function, use a router with a DHCP function.
On the WLAN screen, tap the Wi-Fi name, and then enter password to connect to the Step 5
network.
To Next Page
Loading...
Need help?
General
