Function of RA Indoor Unit SiBE121123_A
67 Function and Control
1.12 HOME LEAVE Operation
Outline Floor / Ceiling Suspended Dual Type, Duct Connected Type
HOME LEAVE operation is a function that allows you to record your favorite set temperature
and airflow rate. You can start your favorite operation mode simply by pressing the [HOME
LEAVE] button on the remote controller.
Detail 1. Start of Function
The function starts when the [HOME LEAVE] button is pressed in cooling operation, heating
operation (including POWERFUL operation), or while the operation is stopped. If this button is
pressed in POWERFUL operation, the POWERFUL operation is canceled and this function
becomes effective.
The [HOME LEAVE] button is ineffective in dry operation and fan operation.
2. Details of Function
A mark representing HOME LEAVE is indicated on the display of the remote controller. The
indoor unit is operated according to the set temperature and airflow rate for HOME LEAVE
which were pre-set in the memory of the remote controller.
The LED (red) of indoor unit representing HOME LEAVE lights up. (It goes out when the
operation is stopped.)
3. End of Function
The function ends when the [HOME LEAVE] button is pressed again during HOME LEAVE
operation or when the [POWERFUL] button is pressed.
<Cooling>
HOME LEAVE operation
Start
Stop
(R1366)
Time
Set temp.
Normal operation
“HOME LEAVE operation”
set temp.
Normal operation
<Heating>
(R1367)
Time
Set temp.
“HOME LEAVE operation”
set temp.
HOME LEAVE operation
Start
Stop
Normal operation
Normal operation
To Next Page
Loading...
Need help?
General
