Danfoss AKA 245 User Manual

GATEWAY, Code. Access
display and access code
Access to the gateway takes place with control panel AKA 21 in the same way as for other controllers
on DANBUSS.
Shown in the AKA 21 display are the units that are connected to DANBUSS. The AKA 245 gate way is
symbolised with a “G”.
< 125 > 125
AAE A A G
AKA 245 with assigned address = 125 is depicted here
A gateway that has been assigned the master function will have address No. 125.
When you push “arrow right”, the display will show addresses higher than 16.
Select gateway by using the “+/ON” or the “-/OFF” key, and then pushing “Enter”.
The following access display will now appear in connection with a PC gateway:
PC GATEWAY
Push “arrow down” to proceed to the menu where the access code has to be keyed.
Code
XX
Factory-set access codes:
Extended access code = 40. This will give access up to and including the menu section “TIME
SETTINGS”.
Service access code = 99. This will give you access to the whole unit.
After keying the code, push “Enter”, and the access display will appear again. Now push “arrow right” to
continue the setup.
AKA 245 Manual RS8DT102 © Danfoss 09/2004 25

Danfoss AKA 245 Specifications

General

Brand	Danfoss
Model	AKA 245
Category	Gateway
Language	English