Time setting.
Clock function
“Time setting” Access to setting of timer and changeover between summer and winter time.
The timer in the gateway is an annual timer that can change between summer and
winter time.
The timer will itself determine the day of the week based on year and date, and it
will not accept incorrect settings. If an attempt to set the month, for example, is not
crowned with success, it may be because the date has a wrong value.
The timer’s second-counter is zero-set when the minutes are set.
The timer is provided with battery back-up and will keep on working if there is a
power failure.
“Year” Setting of year.
“Month” Setting of month
“Date” Setting of date.
“Hour” Setting of time.
“Minute” Setting of minute.
“Summer time” Display of changeover between summer and winter time, and access to settings.
Select either “off ”, “auto” or “manual”:
“Off ” Changeover between summer and winter time interrupted.
“Auto” Changeover is performed automatically based on the rules applying to most of
Europe. (Last Sunday in March and October)
“Manual” Here you specify the date and hour of the two changeovers. The change over can
only be made with full hours. The settings will remain valid, until a new setting is
made.
If “Auto” has been selected, settings cannot be made.
“Start” Access display for setting the start of the summer time.
“Stop” Access display for setting the stop of the summer time.
“Month”, “Date”, “Hour”:
Setting of time
26 Manual RS8DT102 © Danfoss 09/2004 AKA 245
To Next Page
Loading...
Need help?
General
