3 Transport, unpacking and positioning
3.1
Transporting heat pump
Caution! The heat pump must always be transported and stored standing and in a dry environment. If the
heat pump is laid on the incorrect side it may become seriously damaged as the oil in the compressor can
run out in the pressure pipe and therefore prevent normal function.
Caution! Always secure the heat pump so that it cannot tip over during transportation.
3.2 Unpacking heat pump
3.2.1
Delivery check
1. Check that there is no transport damage.
2.
Remove the packaging and check that the delivery contains the following components.
Table 1. Supplied contents
Quantity Name
1 Heat pump
1 Control unit
1 Document set
1 Package (1 x shut-off valve with filter, 1 x outdoor sensor)
3.3 Positioning the heat pump
3.3.1
Recommended location
When positioning the heat pump, note the following:
Caution! The heat pump must be positioned outdoors on a stable base. The floor must be able to support
the gross weight of the heat pump. (see Technical data)
Caution! The heat pump must be secured on a stable base, for example a cast foundation. All four
mounting points must be secured to the base.
Installation instructions VMGFD102 – 9
To Next Page
Loading...
Need help?
General