Parameter Meaning
CURVE +5 Local increase or reduction of CURVE at an outdoor temperature of +5°C. Shown in the graph
for CURVE.
Factory setting: 0°C, range: -5°C – 5°C
CURVE 0 Local increase or reduction of CURVE at an outdoor temperature of 0°C. Shown in the graph
for CURVE.
Factory setting: 0°C, range: -5°C – 5°C
CURVE -5 Local increase or reduction of CURVE at an outdoor temperature of -5°C. Shown in the graph
for CURVE.
Factory setting: 0°C, range: -5°C – 5°C
DURING COOLING During production of cooling the shunt group can be adjusted.
Factory setting: AUTO, range: AUTO, OPEN, CLOSED
CONSTANT TEMP Controlling the shunt group against a constant temperature is an alternative to the control
using a heat curve given above. Control using constant temperature is selected using the
parameter CONSTANT TEMP in the Service menu.
Factory setting: 18°C, range: 10°C – 30°C
SETBACK TEMP The temperature the shunt group works with when the temperature reduction is activated in
the menu CALENDAR.
Factory setting: 18°C, range: 10°C – 30°C
9.5 HOT WATER
Parameter Meaning
HOT WATER Allows hot water production.
Factory setting: , range: – ON
TOP-UP Forced hot water production with compressor and aux. heater.
Factory setting: , range: – ON
9.6 COOLING
Parameter Meaning
COOLING Allows production of cooling.
Factory setting: , range: – ON
START Temperature on the return sensor for start of cooling production.
Factory setting: 25°C, range: STOP + 5°C – MAX START TEMP
Installation instructions VMGFD102 – 49
To Next Page
Loading...
Need help?
General