Status/Next Service 28
Status/Supply 28
Status/Read Outs Parameters 29
Alarms/Alarm Parameters 31
Alarms/Event Log Parameters 33
Info 35
Non-displayed Parameters 36
Troubleshooting 38
Overview 38
Warnings and Alarms 38
Troubleshooting Tips 39
The valve does not appear to close or stay closed completely 39
The valve does not appear to be moving to the correct position 39
The valve does not appear to be opening fast enough or seems too fast 40
The valve position feedback signal is not working with the customer supplied
controller/PLC 40
Frequently Asked Questions 41
What happens in the event of a power failure? 41
How much power do I need to supply to the ICAD? 41
How can I monitor the valve position remotely? 41
At what minimum OD%/mA will the ICAD automatically close and calibrate? 41
If the 4–20 mA signal is lost while the valve is open, will the ICAD close the valve? 41
How many turns/revolutions with the manual tool will fully open/close ICM valve? 41
Does the ICAD make a high frequency noise? 42
What size wire gauge is recommended to run to the ICADs? 42
When running wire to the ICADs, does the wire need to be shielded? 42
Online support 43
ICM and ICMTS Motorized Valves with ICAD Actuators
© Danfoss | Climate Solutions | 2024.01 BC465027827472en-000102 | 3
To Next Page
Loading...
Need help?
General
