ccessories
■ Accessories
■ Overview
The following optional accessory items are available
for use with MCD 200 soft starters:
• MCD 200 Remote Operator
(Order Code 175G9004)
• MCD 200 Modbus Module
(Order Code 175G9000)
• MCD 200 Profibus Module
(Order Code 175G9001)
• MCD 200 DeviceNet Module
(Order Code 175G9002)
• MCD 200 AS-i Module
(Order Code 175G9003)
• MCD PC Software
Accessory items are integrated with the MCD 200
soft starters by means of a plug-in module as shown
below.
35 mm
(1.38 inches)
177HA261.10
Control power and mains supply must be
removed from the MCD 200 before
attachment or removal of accessory
modules. Failure to do so may result in
equipment damage.
■ MCD 200 Remote Operator
Order Code: 175G9004
The Danfoss Remote Operator can be used with
MCD 201, MCD 202 and MCD 3000 to provide the
following functionality:
Feature MCD
201
MCD
202
MCD
3000
Pushbutton Control
(Start, Stop, Reset)
zzz
Starter Status LEDs
(Starting, Running, Tripped)
zzz
Motor Current Display zz
Motor Temperature Display zz
Trip Code Display zzz
4-20 mA Analogue Output
(Motor Current)
zz
See the Remote Operator Operating Instructions for
further details.
■
MCD 200 Modbus Module
Order Code: 175G9000
The Modbus Module supports Modbus RTU and AP
ASCII. See the Modbus Module Operating
Instructions for further details.
■
MCD 200 Profibus Module
Order Code: 175G9001
The Profibus Module can be used with MCD 200 soft
starters for control and monitoring via a Profibus
network. See the Profibus Module Operating
Instructions for further details.
■
MCD 200 DeviceNet Module
Order Code: 175G9002
The DeviceNet Module can be used with MCD 200
soft starters for control and monitoring via a
DeviceNet network. See the DeviceNet Module
Operating Instructions for further details.
■
MCD 200 AS-i Module
Order Code: 175G9003
Under development.
To Next Page
Loading...
Need help?
General
