Danfoss PVED-CLS Startup Guide

PVED-CLS SEHS protocol data P3311-P3333
Example parameter settings
If the parameter change is not described below or conditions are not met, use the default values.
Parameter Condition for value change
P3311-P3317 Leave at default unless PGN's conflict with others on the CAN bus or another addressing
scheme is desired
P3328 Leave at default unless PGN's conflict with others on the CAN bus or another addressing
scheme is desired
P3332 Leave at default unless PGN's conflict with others on the CAN bus or another addressing
scheme is desired
P3329 Leave at default unless PGN's conflict with others on the CAN bus or another addressing
scheme is desired
P3318-P3323 Leave at default unless PGN's conflict with others on the CAN bus or another addressing
scheme is desired
P3324 Leave at default unless "Proprietary B" message formatting of MMI is desired. If "Proprietary
B" is chosen, PGN offsets can be edited via P3325.
Approve the parameters by following the steps in PVED-CLS parameter acceptance on page 8.
Application Guide
PVED-CLS startup guide
Parameter setting
©
Danfoss | October 2018 AB285975085591en-000101 | 15

Danfoss PVED-CLS Specifications

General

Brand	Danfoss
Model	PVED-CLS
Category	Controller
Language	English