PVAS Stay Bolts kit for various PVG combinations consist of three tie rods, six washers, six nuts and O-ring.
Use the guide and reference tables how to choose PVAS kit.
The tie rods are inserted through the entire length of the PVG valve stack. The nuts are tightened at the
pump side and at the end plate.
To find the PVAS kit that fits your PVG 16 valve stack, you need to go to the table PVG 16 modules total
length and weight on page 93 and find the length. Then go to the table PVAS Part Numbers on page 93
and find the matching part number.
For stay bolts for a PVG 32/16 combination, see this PVG 32/16 Combinations on page 94.
Stay bolts for PVG 256/128/32/16 combinations consist of two different kits. See PVG 256/128/32/16
Combinations on page 95 to find the right kits for your combination.
Combinations with PVG 100 and PVG 120 requires special PVAS kits. These are not included in the PVAS
table.
Technical Information
PVG 16 Proportional Valve Group
PVAS Stay Bolts
92 |
©
Danfoss | December 2018 BC00000211en-000901
To Next Page
Loading...
Need help?
General
