Electrical installation
Electrical installation
The voltage on the adjustable frequency
drive is dangerous when the unit is con-
nected to mains. Incorrect installation of
the motor or the adjustable frequency
drive may lead to material damage or se-
rious injury or it may be fatal. Consequent-
ly, the instructions in this manual as well
as national and local rules and safety reg-
ulations must be complied with.
Touching the electrical parts may be fatal,
even after the mains supply has been dis-
connected.
Using VLT 5001-5006, 200-240
V and 380-500 V: wait at least 4
minutes.
Using VLT 5008-5052, 200-240
V: wait at least 15 minutes.
Using VLT 5008-5062, 380-500
V: wait at least 15 minutes.
Using VLT 5072-5302, 380-500
V: wait at least 20 minutes.
Using VLT 5350-5500, 380-500
V: wait at least 15 minutes.
Using VLT 5001-5005, 525-600
V: wait at least 4 minutes.
Using VLT 5006-5022, 525-600
V: wait at least 15 minutes.
Using VLT 5027-5250, 525-600
V: wait at least 30 minutes.
NOTE
It is the user's or certified electrician's re-
sponsibility to ensure correct earthing and
protection in accordance with applicable
national and local norms and standards.
All terminals for the control cables are located under
the protective cover of the adjustable frequency drive.
The protective cover (see drawing) can be removed by
means of a pointed object - a screwdriver or similar.
Once the protective cover has been removed, the ac-
tual EMC-correct installation can start. See drawings
in the section, EMC correct installation.
VLT
®
5000 Series
MG.51.C5.22 - VLT
p
is a registered Danfoss trademark. 47
Installation
To Next Page
Loading...
Need help?
General