Danfoss VLT 5003 User Manual

The procedure for changing data depends on whether
the selected parameter represents a numerical data
value or a text value.
Changing a text value
If the selected parameter is a text value, the text value
is changed by means of the [+/-] keys.
50.0 Hz
FREQUENCY
001 LANGUAGE
ENGLISH
The bottom display line shows the text value that will
be entered (saved) when acknowledgement is given
[OK].
Change of group of numeric data values
If the chosen parameter represents a numeric data
value, the chosen data value is changed by means of
the [+/-] keys.
50.0 HZ
SETUP
1
FREQUENCY
102 MOTOR POWER
0.37 KW
SETUP
1
50.0 HZ
FREQUENCY
102 MOTOR POWER
0.55 KW
SETUP
1
The chosen data value is indicated by the digit flash-
ing.
The bottom display line shows the data value that will
be entered (saved) when signing off with [OK].
Infinitely variable change of numericdata value
If the chosen parameter represents a numeric data
value, a digit is first selected by means of the [<>] keys.
50.0 Hz
SETUP
1
FREQUENCY
130 START FREQUENCY
09.0 HZ
Then the chosen digit is changed infinitely variably by
means of the [+/-] keys:
50.0 Hz
SETUP
1
FREQUENCY
130 START FREQUENCY
10.0 HZ
The chosen digit is indicated by the digit flashing. The
bottom display line shows the data value that will be
entered (saved) when signing off with [OK].
Changing of data value, step-by-step
Certain parameters can be changed step by step or
infinitely variably. This applies to Motor power (param-
eter 102), Motor voltage (parameter 103) and Motor
frequency (parameter 104).
The parameters are changed both as a group of nu-
meric data values and as numeric data values infinitely
variably.
Read out and programming of indexed parame-
ters
Parameters are indexed when placed in a rolling stack.
Parameter 615 - 617 contain a historical log which can
be read out. Choose the actual parameter, press the
[CHANGE DATA] key and use the [+] and [-] keys to
scroll through the log of values. During the read out
line 4 of the display will flash.
If a bus option is mounted in the drive, the program-
ming of parameter 915 - 916 needs to be carried
through in the following way:
Choose the actual parameter, press the [CHANGE
DATA] key and use the [+] and [-] keys to scroll through
the different indexed values. To change the value of
the parameter, select the indexed value and press the
[CHANGE DATA] key. Using the [+] and [-] keys the
VLT
®
5000 Series
76 MG.51.C5.22 - VLT
p
is a registered Danfoss trademark.

Danfoss VLT 5003 Specifications

General

Brand	Danfoss
Model	VLT 5003
Category	DC Drives
Language	English