Danfoss VLT Flow Drive FC 111 User Manual

•
•
•
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
1.
2.
3.
4.
3.2.2.6 Changes Made Function
The changes made function lists all parameters changed from default settings.
The list shows only parameters that have been changed in the current edit setup.
Parameters that have been reset to default values are not listed.
The message Empty indicates that no parameters have been changed.
3.2.2.7 Changing Parameter Settings
Procedure
To enter the Quick Menu, press the [Menu] key until the indicator in the display is placed above Quick Menu.
Press [▵] [▿] to select the wizard, closed-loop setup, motor setup, or changes made.
Press [OK].
Press [▵] [▿] to browse through the parameters in the Quick Menu.
Press [OK] to select a parameter.
Press [▵] [▿] to change the value of a parameter setting.
Press [OK] to accept the change.
Press either [Back] twice to enter Status, or press [Menu] once to enter the Main Menu.
3.2.2.8 Accessing All Parameters via the Main Menu
Procedure
Press the [Menu] key until the indicator in the display is placed above Main Menu.
Press [▵] [▿] to browse through the parameter groups.
Press [OK] to select a parameter group.
Press [▵] [▿] to browse through the parameters in the specific group.
Press [OK] to select the parameter.
Press [▵] [▿] to set/change the parameter value.
Press [OK] to accept the change.
3.2.3 Main Menu
Press [Menu] to access the main menu and program all parameters. The main menu parameters can be accessed readily unless a
password has been created via parameter 0-60 Main Menu Password.
For most applications, it is not necessary to access the main menu parameters. The quick menu provides the simplest and quickest
access to the typical required parameters.
3.3 Quick Transfer of Parameter Settings between Multiple Drives
When the set-up of a drive is completed, store the data in the LCP. Then connect the LCP to another drive and copy the parameter
settings to the new drive.
3.3.1 Transferring Data from the Drive to the LCP
Procedure
Go to parameter 0-50 LCP Copy.
Press [OK].
Select [1] All to LCP.
Press [OK].
3.3.2 Transferring Data from the LCP to the Drive
Procedure
Go to parameter 0-50 LCP Copy.
Press [OK].
Select [2] All from LCP.
Press [OK].
3.4 Readout and Programming of Indexed Parameters
Procedure
AU363928304090en-000101 / 130R098226 | Danfoss A/S © 2021.07
Programming
VLT® Flow Drive FC 111
Programming Guide

Danfoss VLT Flow Drive FC 111 Specifications

General

Brand	Danfoss
Model	VLT Flow Drive FC 111
Category	DC Drives
Language	English