Danfoss VLT MCD 202 Installation Guide

4 Connection
4.1 Soft Starter Connection
The EtherNet/IP module is powered from the soft starter.
N O T I C E
The EtherNet/IP module is not suitable for use with MCD 200 soft starters using 380/440 V AC control voltage.
A1
N2
2
3
1
e77ha620.10
Illustration 2: Connecting MCD 200
1
Soft starter
A1, N2: Stop input
2
EtherNet/IP module
3
RJ45 Ethernet ports
25
17
18
2
3
1
e77ha621.10
Illustration 3: Connecting MCD 500
1
Soft starter (remote mode)
17, 18: Stop input
25, 18: Reset input
2
EtherNet/IP module
3
RJ45 Ethernet ports
4.2 Network Connection
4.2.1 Ethernet Ports
The device has 2 Ethernet ports. If only 1 connection is required, either port can be used.
4.2.2 Cables
When connecting to the device, make sure that the cables are of 1 of the following categories:
AN427641276310en-000101 / 175R1187 | 11Danfoss A/S © 2022.10
Connection
EtherNet/IP Module
Installation Guide

Danfoss VLT MCD 202 Specifications

General

Brand	Danfoss
Model	VLT MCD 202
Category	Controller
Language	English