Danfoss VLT MCD 202 Installation Guide

•
•
8.3.3.2 Status Codes for Acyclic Services
Table 8: Status Codes Returned in Response to Get/Set Attribute Single
Status code
Status name
Details
00d (0x00)
Success
This code is returned when:
the register mapped for "Get Attribute Single" is successfully read.
the register mapped for "Set Attribute Single" is successfully set.
03d (0x03)
Invalid parameter value
–
05d (0x05)
Path destination unknown
The mapped register does not exist.
08d (0x08)
Service not supported
The requested service is not available for this object class/instance.
09d (0x09)
Invalid attribute value
This code only applies to the service Set Attribute Single. It is returned if the value is
out of range of the mapped register.
15d (0x0E)
Attribute not settable
This code only applies to the service Set Attribute Single. It is returned if the mapped
register is read-only.
20d (0x14)
Attribute not supported
The attribute specified in the request is not supported.
22d (0x16)
Object does not exist
The object specified does not exist in the device.
8.4 Trip Codes
Code
Description
0
No trip
11
Input A trip
20
Motor overload
21
Heat sink overtemperature
23
L1 phase loss
24
L2 phase loss
25
L3 phase loss
26
Current imbalance
28
Instantaneous overcurrent
29
Undercurrent
50
Power loss
54
Phase sequence
55
Frequency
60
Unsupported option (function not available in inside delta)
61
FLC too high
62
Parameter out of range
70
Miscellaneous
AN427641276310en-000101 / 175R1187 | 29Danfoss A/S © 2022.10
Packet Structures
EtherNet/IP Module
Installation Guide

Danfoss VLT MCD 202 Specifications

General

Brand	Danfoss
Model	VLT MCD 202
Category	Controller
Language	English