Danfoss VLT Micro Drive FC 51 Series Programming Guide

3.4. Main Menu
The Main Menu gives access to all parameters.
1. To enter the Main Menu, press [MENU] key until indicator in
display is placed above
Main Menu .
2. Use [Ⴃ] [Ⴍ] to browse through the parameter groups.
3. Press [OK] to select a parameter group.
4. Use [Ⴃ] [Ⴍ] to browse through the parameters in the specific
group.
5. Press [OK] to select the parameter.
6.
Use [Ⴃ] [Ⴍ] to set/change the parameter value.
7. Press [OK] to accept the value.
8. To exit, press either [Back] twice to enter
Quick Menu , or press
[Menu] once to enter
Status .
Illustration 3.10: Indicating Main Menu mode
3. Programming VLT
p
Micro Drive FC 51
10 MG.02.C4.02 - VLT
p
is a registered Danfoss trademark
3

Danfoss VLT Micro Drive FC 51 Series Specifications

General

Brand	Danfoss
Model	VLT Micro Drive FC 51 Series
Category	Media Converter
Language	English