Illustration 5.3 Path in the Hardware Catalogue
Open a Project, set up the Hardware and add a PROFINET
Master system. Select Danfoss FC PN then drag and drop it
onto the PROFINET IO system.
Open the properties for the inserted frequency converter,
to enter the device name..
NOTICE
The name must match the name in 12-08 Host Name. If
the checkmark Assign IP address via the IO controller is
set, the controller downloads the IP address to the IO
device that has the corresponding device name. The IP
address is stored in the non volatile memory of the
frequency converters.
Illustration 5.4 Set Up the Hardware and Add a PROFINET
Master System
The next step is to set up the peripheral input and output
data. Data set up in the peripheral area is transmitted
cyclically via telegrams/PPO types. In the example below, a
PPO type 6 is dragged and dropped to slot 1.
See the PPO types in chapter 6 How to Control the
Frequency Converter for more information.
How to Configure the System Operating Instructions
MG90U302 Danfoss A/S © Rev. 2014-02-27 All rights reserved. 21
5 5
To Next Page
Loading...
Need help?
General