Programmable SyncPos motion controller
MG.10.J8.02 – VLT is a registered Danfoss trade mark
84
PC Software Interface in MTC10 Mode
■ ■
■ ■
■ "FILE" Menu in MCT10 Mode
Due to the fact that all file handling is done by
MCT10, the following items of the File menu are
disabled:
"FILE" → "NEW"
New files have to be created via MCT10.
"FILE" → "OPEN"
Select the file via the MCT10. SyncPos and with that
the file is opened automatically.
"FILE" → "SAVE AS"
Please use the features of the MCT10, to rename a
program file (*.m) or copy it thereby. But you can →
"SAVE" the actual program or changes with the
same file name in SyncPos.
"FILE" → "PRINT" and → "PRINT SETUP"
You can print program files (*.m) via the MCT10. The
print setup has to be done via the MCT10 of course.
"FILE" → "LAST FILE"
There is no last file list, because SyncPos can not
open up any file, if running in MCT10 mode.
■ ■
■ ■
■ "DEVELOPMENT" Menu in MCT10 Mode
Online Mode
In Online Mode there is no difference to the SyncPos
user interface; you can use all functions.
Offline Mode
In Offline Mode all functions, which require access
to the drive, can not be used. Most of the menu
items are disabled:
But following two items you can use in MTC10 offline
mode:
"DEVELOPMENT" → "SYNTAX CHECK"
This can be used to check the syntax of the editor’s
program file.
"DEVELOPMENT" → "COMMAND LIST"
The Command List offers a limited functionality. It
can just be used to insert commands in the editor’s
program file or to get context-sensitive help of a
command.
But it is not possible to execute any of the com-
mands directly or to move the drive to position.
To Next Page
Loading...
Need help?
General
