Programmable SyncPos motion controller
MG.10.J8.02 – VLT is a registered Danfoss trade mark
88
The following chapters describe how to program using SyncPos. Beginners should
read the basic explanations on the programming language SyncPos, i.e. program
layout, command structure, interrupt, elements of the programming language,
arithmetic and user unit. Experienced users should inform themselves about the
SyncPos-specific basic principles, e.g. user unit or parameters.
All commands are described in the Software Reference, first in a general over-
view and then alphabetically ordered, in detail and complemented with short
examples. You can reconstruct as many as 50 programs with assistance of the
information in the example programs in the Online-Help.
And in chapter Parameter Reference all the parameters are described, first in
general and then in detail.
Programming with SyncPos
To Next Page
Loading...
Need help?
General
