A-16 SD460 Laminating System
b. Select the print and lamination options you want to test, and then click Run to print a
test card. You also can select to debow the test card, and impress the card if an impresser
is installed.
Verify the Test Card
Examine the test cards to verify the following.
The overlays are being applied properly:
Each overlay is applied completely to the card.
The material adheres well to the edges of the card.
The overlay does not come off when the card is bent or twisted.
The card is debowed correctly.
The impression is positioned correctly and has the proper depth.
If you need to adjust the laminator settings, refer to the following Printer Manager sections:
“Laminator” on page 66 and “LaminateType” on page 73.
To Previous Page
Loading...
Need help?
General
