SD260L/SD360/SD460 Installation and Administrator’s Guide 77
Set Job Queue State
Enter or select values prior to shipping the printer or system to or from repair facilities.
1. Enter the current password for the printer or system.
2. Enter a new password for the printer or system.
3. Re-enter the new password for verification.
4. Select a state:
Online—The printer performs normally.
Suspend—Deactivates the printer, but allows for some exception jobs.
Offline—Deactivates the printer for transportation.
5. Click Set Job Queue State to apply the changes.
This setting is used primarily for financial printers. Contact your service provider
for more information.
Field Value Description
Current Password Enter the currently set password.
Leave the field blank if no password
was previously set.
Next Password Enter a new password. A blank value
means that no password is required or
leaves the current password
unchanged, depending on the
settings.
Confirm Next Password Retype the Next Password.
State Online
Suspend
Offline
StartJob succeeds if there is space in
the queue.
StartJob succeeds if there is space in
the queue and exceptionJob=true.
StartJob does not succeed under any
circumstances.
To re-enable an “Offline” printer and set it back to “Online,” you must enter the same
password that was used to set it to “Offline.”
To Next Page
Loading...
Need help?
General
