SD260L/SD360/SD460 Installation and Administrator’s Guide 3
Site Requirements
Set up and use the printer in an environment that meets the following requirements.
Place the printer in an environment with temperatures ranging from 60° to 95°F (15° to 35°C).
Use a single-phase, 3-wire, grounded receptacle.
Place the printer and its supplies in a clean office environment, keeping paper and foreign
materials off of the equipment.
Place the printer in a location that provides the following:
A sturdy, level surface. Avoid unstable locations.
A surface that allows easy user access. Refer to “Printer Dimensions” for more
information.
Enough space to open all printer doors and to access power cords and data cables. Refer
to “Clearance Requirements” on page 4.
Enough space around the printer to allow for ventilation.
Place the printer away from direct sunlight.
Do not place the printer near heating ducts, fans, or other air vents.
Do not use the printer for purposes other than the intended use.
Printer Dimensions
The external printer dimensions are shown in the following illustration.
8.8 in
224 mm
6.87 in
174 mm
21.2 in
539 mm
To Next Page
Loading...
Need help?
General
Weight and Dimensions
