Label ID: Set Individually Per Symbology
Product Reference Guide
265
Label ID: Set Individually Per Symbology — continued
Table 18. Label ID Examples
STEP ACTION EXAMPLES
1. Scan the ENTER/EXIT bar code (Reader enters Programming Mode)
2.
Determine placement of the Label
ID characters BEFORE or AFTER
with regard to scanned data using
Label ID Control on
page 71
Enable as Prefix Enable as Suffix Enable as Prefix Enable as Suffix
3.
Scan the bar code selecting the
symbology type you wish to
designate label ID characters for
using
Label ID Symbology
Selection, starting on page
72
.
GS1 DataBar
Omnidirectional
Code 39
Interleaved 2 of 5 Code 32
4.
Custom Label ID example (desired
characters):
D B * = C 3 +P H
5.
Find hex equivalents from the
ASCII table (inside back cover),
then scan in these digits/
characters using the bar codes in
the section:
Keypad, starting
on page 297
. f you make a
mistake before the last character,
scan the CANCEL bar code to
abort and not save the entry
string. You can then start again at
the beginning.
44 42 2A 3D 43 33 2B 50 48
6. Scan theENTER/EXIT bar code (Reader exits Label ID entry)
7.
Scan the ENTER/EXIT bar code
once again
(Reader exits Programming Mode)
Result:
DB*[bar code
data]
[bar code
data]=C3
+[bar code data] [bar code data]PH
To Next Page
Loading...
Need help?
General
Weight and Dimensions
