Datamax M-Class Mark II Maintenance Manual

Removal and Replacement
4-25
3. Slide the Supply Hub and Plastic Spacer out of the Assembly Casting.
Screw
Washer
Plastic
Spacer
Supply
Hub
Assembly
Casting
Supply
Hub Shaft
Installation:
1. Slide the Supply Hub Shaft through the Plastic Spacer and partially into the Assembly
Casting.
2. After ensuring that the Pin on the Supply Hub Shaft engages the Notch in the Assembly
Casting, slide the Supply Hub Shaft completely through then install the Washer and
secure the components to the Assembly Casting with the Screw.
Pin
Supply
Hub
Shaft
Notch
3. Install the Thermal Transfer Assembly; see Section 4.9.

Datamax M-Class Mark II Specifications

General

Brand	Datamax
Model	M-Class Mark II
Category	Label Maker
Language	English