PROGRAMMER’S REFERENCE MANUAL
Printer settings
Page 42
Printer settings
The printer settings can be set on command from the host computer. The initial settings
used at power-up are stored in non-volatile memory. Some settings can be changed during
operation while others always retain their power-up value. Using the commands described
below can access all of the parameters, but most of the common settings are available via the
configuration menu, accessible through the COM ports, Telnet port or the built-in webserver in
the printer. See section ‘configuration menu’ below.
Get current value: !X<i>
The printer responds with the current value of the parameter <i>, followed by a carriage
return character.
Set value: !Y<i> <n>
The parameter <i> is set to <n>, which must be a decimal number. Not all parameters can
be set, see the table below.
Make changes permanent: !Z
The current settings are written into the non-volatile memory so that they will still be in
effect when the printer has been switched off.
Note! All parameters that do not have the
5
suffix must be made permanent with the !Z
command. The printer must then be switched off and back on (or restarted by
command) before the change becomes active.
To Next Page
Loading...
Need help?
General