Setting up Network Printing 33
8.
On the
Printer Software
screen, specify the software that you want to install and installation
path, and then click
Next
. At this point, the wireless setting specified on the
Enter Wireless
Network Settings
screen is sent to the printer.
9.
On the
Wireless configuration is now complete
screen, click
Next
. Since wireless setting is
already made to your computer, no operation is necessary on this screen.
10.
On the
Setting-Ready Printer
screen, verify that the correct IP address is assigned to the
printer to which the wireless setting is set, and then click
Install
.
11.
If you select the
I am setting up this printer on server
check box on the
Select Printer
screen
and also select the
PostScript Driver
check box on the
Enter Printer Settings
screen, the
Adobe Systems Inc. License Agreement
screen appears. Select the
I accept the terms of the
license agreement
option button, and then click
Install
.
12.
On the
Congratulations!
screen, click
Finish
to complete the installation. A test page will be
printed with the installed printer by clicking the
Print Test Page
button.
Scene 2. Construct new wireless network environment for both computer and printer (When wireless
setting needs to be set to your computer)
1.
Insert the
Drivers and Utilities
CD into your computer.
2.
The
Drivers and Utilities
CD should launch the installation software automatically.
If the CD does not automatically launch, click
Start
→
Run
, type
D:\Setup.exe
(where D
is the drive letter of your CD), and then click
OK
.
3.
Select the
Network Installation
option button, and then click
Next
.
4.
Select the
Configure Wireless Printer using a USB connection (Recommended)
option
button, and then click
Next
.
5.
Reset the wireless setting of the printer following the steps on the
Reset Wireless Setting
screen.
6.
In the list on the
Select Printer
screen, check the check box of the target printer that you are
making wireless setting for, and then click
Next
.
NOTE: When you enter a fixed IP address, avoid the “169.254.xxx.xxx” address used by AutoIP.
7.
On the
Enter Wireless Network Settings
screen, set each wireless setting item, and then click
Next
. When you select the
Fixed IP
option button for
IP address assignment
, click
Settings...
and enter the IP address and subnet mask on the screen.
8.
Set each item on the
Enter Printer Settings
screen, and then click
Next
.
9.
On the
Printer Software
screen, specify the software that you want to install and installation
path, and then click
Next
. At this point, the wireless setting specified on the
Enter Wireless
Network Settings
screen is sent to the printer.
10.
On the
Wireless configuration is now complete
screen, create the wireless setting sent to the
printer on your computer following the steps below, and then click
Next
.
To Next Page
Loading...
Need help?
General
