30 Setting up Network Printing
2.
Under the TCP/IP heading, verify the IP address.
If the IP address is
0.0.0.0
, wait for a few minutes to resolve the IP address automatically,
and then print the Printer Settings page again.
Printer Setup
1.
Insert the
Drivers and Utilities
CD into your computer to launch the installation software.
NOTE: If the CD does not automatically launch, click Start → Run, and then type D:\setup.exe (where D
is the drive letter of your CD), and then click OK.
2.
Select
Network Installation
, and then click
Next
.
3.
Select
Configure New Wired Printer
, or
Install Driver and Software for existing network
printer
, and then click
Next
.
4.
For local installation, select
Local Installation
, and then click
Next
.
For remote installation:
a.
Select
Remote Installation
, and then click
Next
.
NOTE: Remote installation between Windows NT and the following operating systems is not supported.
- Windows XP Professional x64 Edition
- Windows Server 2003 x64 Edition
NOTE: Installation on Windows XP Home Edition is not supported.
b.
Enter the computer name, user ID, and password. Then, click
Add
.
c.
Click
Next
.
5.
Select the printer you want to install from the printer list, and then click
Next
. If the target
printer is not displayed on the list, click
Update
to refresh the list or click
Add Printer
to add
a printer to the list manually. You may specify the IP address and port name at this point.
If you have installed this printer on the server computer, select the
I am setting this printer
on a server
check box.
NOTE: When using AutoIP, 0.0.0.0 is displayed in the installer. Before you can continue, you must
enter a valid IP address.
6.
Specify the printer settings, and then click
Next
.
a.
Enter the printer name.
b.
If you want other users on the network to access this printer, select
Share this printer
with other computers on the network
, and then enter a share name that users will easily
identify.
c.
If you want to set a printer as the default, select the
Set this printer as default
check box.
d.
If you want to restrict color printing, select the appropriate
ColorTrack
option. Enter the
password when
Color-Password Enabled
is selected for
ColorTrack
.