32 Setting up Network Printing
Determining the Wireless Network Settings
You need to know the settings for the wireless network to set up the wireless printer. For details of
the settings, contact your network administrator.
Wireless Installation using USB connection
NOTE: The optional multi protocol card with the Wireless LAN Adapter attached must be installed on the
printer.
Scene 1. Install a printer to the already-operating wireless network (When wireless setting is already
set to your computer)
1.
Insert the
Drivers and Utilities
CD into your computer.
2.
The
Drivers and Utilities
CD should launch the installation software automatically.
If the CD does not automatically launch, click
Start
→
Run
, type
D:\Setup.exe
(where D
is the drive letter of your CD), and then click
OK
.
3.
Select the
Network Installation
option button, and then click
Next
.
4.
Select the
Configure Wireless Printer using a USB connection (Recommended)
option
button, and then click
Next
.
5.
Reset the wireless setting of the printer following the steps on the
Reset Wireless Setting
screen.
6.
In the list on the
Select Printer
screen, check the check box of the target printer that you are
making wireless setting for, and then click
Next
. On the
Enter Wireless Network Settings
screen, set each wireless setting item, and then click
Next
. When you select the
Fixed IP
option button for
IP address assignment
, click
Settings...
and enter the IP address and subnet
mask on the screen.
NOTE: When you enter a fixed IP address, avoid the “169.254.xxx.xxx” address used by AutoIP.
7.
Set each item on the
Enter Printer Settings
screen, and then click
Next
.
Wireless
Settings
SSID Specifies the name () that identifies the wireless network. Up to 32
alphanumeric characters.
Network Type Specifies the network type from Ad-hoc or Infrastructure.
Security
Settings
Security Selects the security method from No security, WEP, WPA-PSK
TKIP and WPA-PSK AES.
Transmit Key Specifies the transmit key from the list.
WEP Key Specified the WEP key set used through the wireless network only
when WEP is selected for Security.
Pass Phrase Specifies the pass phrase of alphanumeric characters from 8 to 63
bytes long only when WPA-PSX is selected for Encryption.
To Next Page
Loading...
Need help?
General
