Setting up Network Printing 35
NOTE: If the CD does not automatically launch, click Start → Run, and then type D:\setup.exe (where D
is the drive letter of your CD), and then click OK.
2.
Select the
Network Installation
option button, and then click
Next
.
3.
Select the
Configure Wireless Printer using a wireless connection (Advanced)
option
button, and then click
Next
.
4.
Reset the wireless setting of the printer following the steps on the
Reset Wireless Setting
screen.
5.
Create the wireless setting of your computer following the steps shown on the
Enable
Communication with Printer
screen, and then click
Next
.
The steps are as follows.
a.
Select
Network Connections
from Control Panel.
b.
Right-click
Wireless Network Connection
and select
Properties
.
c.
Select the
Wireless Networks
tab.
d.
Make sure the check box for
Use Windows to configure my wireless network settings
is
checked.
NOTE: Be sure to write down the current wireless computer settings in steps d and f so that you
can restore them later.
e.
Click the
Advanced
button.
f.
Select
Computer to Computer (ad hoc) networks only
and close the
Advanced
dialog
box.
g.
Click the
Add
button to display Wireless network properties.
h.
Under the Association tab, enter the following information and click
OK
.
Network name (SSID): dell_device
Network Authentication: Open
Data encryption: Disabled
Ad hoc network: checked
i.
Click the
Move up
button to move the newly added SSID to the top of the list.
j.
Click
OK
to close the
Property
dialog box.
6.
On the
Enter Wireless Network Settings
screen, set each wireless setting item, and then click
Next
.
7.
When you select the
Fixed IP
option button for IP address assignment, click
Settings...
and
enter the IP address and subnet mask on the screen.
NOTE: When you enter a fixed IP address, avoid the “169.254.xxx.xxx” address used by AutoIP.
8.
Set each item on the
Enter Printer Settings
screen, and then click
Next
.
To Next Page
Loading...
Need help?
General
