Setting Up the Monitor 31
Attaching the Cable Cover (for only E2715H)
NOTE: The Cable Cover is detached when the monitor is shipped from the
factory.
To attach the Cable Cover:
1. Fit the two tabs on the bottom part of the Cable Cover to the groove
on the back of the monitor.
2. Press the Cable Cover till it snaps into place.
Removing the Monitor Stand
Note: This is applicable for a monitor with a stand. When any other
stand is bought, please refer to the respective stand setup guide for
the removal instructions.
After placing the monitor panel on a soft cloth or cushion, complete the
following steps to remove the base:
E2015HV:
To Next Page
Loading...
Need help?
General
