Installation
Topics:
• Before You Begin
• Installing in a Rack or Cabinet
• Attaching the Mounting Brackets
• Rack Mounting Safety Considerations
• Installing the S5000 Chassis into a 4-Post Rack or Cabinet
• Rack Grounding
• Important Points to Remember for Installing an Ethernet Module
• Installing an Ethernet Module
• Replacing an Ethernet Module
• Important Points to Remember for Installing a Fibre Channel Module
• Installing a Fibre Channel Module
• Replacing a Fibre-Channel Module
• Important Points to Remember for Installing an AC Power Supply
• Installing an AC Power Supply
• Important Points to Remember for Installing a DC Power Supply
• Assembling and Connecting the Safety Ground Wire for DC Power Supply
• Installing a DC Power Supply
• Installing the Ferrite Bead for DC Power and Return Cables
• Securing Power Cables
• Replacing an AC or DC Power Supply
• Important Points to Remember for Installing a Fan Module
• Installing a Fan Module
• Replacing a Fan Module
• Installing the SFP+ and QSFP+ Optics
• Splitting QSFP+ Ports to SFP+ Ports
• Connecting the Stacking Ports (Optional)
• Connecting Two S5000 Systems
• Connecting Three S5000 Systems
• Supplying Power and Powering Up the System
• Hot-Swapping Units in a Stack
Before You Begin
Before installing the switch, verify that you meet these guidelines:
• Enough clearance to the front of the switch so you can read the LEDs.
• AC/DC power cord reaches from the power outlet to the Utility-panel connector.
• Switch is rack-mounted before you install the power supply modules.
• Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent lighting. Make sure that the cabling is
safely away from other devices that might damage the cables. If needed, allow one rack unit (RU) space between devices to provide
room for cabling.
• Airflow around the switch and through the vents is unrestricted.
• Temperature around the unit does not exceed 104°F (40°C). If the switch is in a closed or multirack assembly, the temperature might
be higher than normal room temperature.
• Humidity around the switch does not exceed 85 percent.
• Altitude at the installation site is below 6600 feet.
6
Installation 15
To Next Page
Loading...
Need help?
General