About this Guide
This guide provides site preparation recommendations, and step-by-step procedures for rack mounting, installing and replacing pluggable
modules, and connecting to a power source.
After you have completed the hardware installation and power-up of the S5000, for software configuration information, refer to the Dell
Networking OS Configuration Guide for the S5000 Switch and for Command Line Interface (CLI) information, refer to the Dell
Networking OS Command Line Reference Guide for the S5000 Switch.
CAUTION:
To avoid electrostatic discharge (ESD) damage, wear grounding wrist straps when handling this equipment.
NOTE: Only trained and qualified personnel can install this equipment. Read this guide before you install and power up
this equipment. This equipment contains two power cords. Disconnect both power cords before servicing.
NOTE: This equipment contains optical transceivers, which comply with the limits of Class 1 laser radiation.
NOTE: When no cable is connected, visible and invisible laser radiation may be emitted from the aperture of the optical
transceiver ports. Avoid exposure to laser radiation and do not stare into open apertures.
Topics:
• Related Publications
Related Publications
For more information about the S5000, refer to the following documents:
• Dell Networking OS Configuration Guide for the S5000 Switch
• Dell Networking OS Command Line Reference Guide for the S5000 Switch
• Dell Networking OS Release Notes for the S5000 Switch
NOTE:
For the most recent documentation and software, visit Support :www.dell.com/support .
1
About this Guide 5
To Next Page
Loading...
Need help?
General