Replacing the speakers
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Using the alignment posts, align and place the left speaker on the palm-rest assembly.
2. Replace the rubber grommets if they are pushed up while replacing the left speaker.
3. Route the speaker cable through the routing guides on the palm-rest assembly.
4. Align and place the status-light board in the slot on the palm-rest assembly.
5. Using the alignment posts, align and place the right speaker on the palm-rest assembly.
6. Replace the rubber grommets if they are pushed up while replacing the right speaker.
7. Connect the speaker cable to the system board.
Post-requisites
Replace the base cover.
20
32 Replacing the speakers
To Next Page
Need help?
General
