Removing the power-button
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the battery.
3 Remove the rear cover.
4 Remove the computer base.
Procedure
1 Open the latch and disconnect the ngerprint-reader board cable from the
ngerprint-reader board.
2 Peel the power-button board cable from the palm-rest assembly.
3 Remove the two screws (M2x3) that secure the power-button board to the
palm-rest assembly.
77
To Next Page
Loading...
Need help?
General
