Replacing the display assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Place the palm-rest assembly on the display assembly.
2 Close the display hinges at an angle of 90 degrees.
3 Replace the two screws (M2.5x5) that secure the display hinges to the palm-
rest assembly.
Post-requisites
1 Replace the computer base.
2 Replace the wireless card.
3 Replace the rear cover.
4 Replace the battery.
5 Replace the base cover.
90
To Next Page
Loading...
Need help?
General
