About this task
The figure indicates the location of the power button with fingerprint and provides a visual representation of the installation
procedure.
Steps
1. Locate the power button with fingerprint slot on your computer.
2. Align and place the power button with fingerprint into the slot on your computer.
3. Install the two (M2x2) screws that secure the power button to chassis of your computer.
Next steps
1. Install the system board.
2. Install the memory module.
3. Install the inner frame.
4. Install the WWAN card.
5. Install the WLAN card.
6. Install the HDD.
7. Install the solid state drive.
8. Install the battery.
9. Install the base cover.
10. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the WLAN card.
5. Remove the WWAN card.
76
Disassembly and reassembly
To Next Page
Loading...
Need help?
General
