Steps
1. Connect the battery cable to the system board.
2. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly.
3. Starting from the bottom-right corner snap the base cover. Work your way around to the middle of the base cover and then
to the bottom-left corner and snap the base cover into place.
4. Replace the eight screws (M2x3) that secure the base cover to the palm-rest and keyboard assembly.
Next steps
NOTE:
After your computer is reassembled and powered on, it prompts for the Real Time Clock (RTC) reset. When the
RTC reset cycle occurs, the computer restarts several times and then an error message is displayed- "Time of day not set".
Enter the BIOS when this error appears and set the date and time on your computer to resume normal functionality.
1. Follow the procedure in After working inside your computer.
Battery
Lithium-ion battery precautions
CAUTION:
● Exercise caution when handling Lithium-ion batteries.
Removing and installing components 17
To Next Page
Loading...
Need help?
General
