Replacing the display back-cover and
antenna assembly
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1. Place the display back-cover and antenna assembly on a clean and flat surface.
2. Replace the display hinges.
3. Place the display panel on to the display back-cover and antenna assembly.
4. Snap the display panel into place.
5. Route the display cable and touchscreen-board cable through the routing guide on the display hinge.
33
60 Replacing the display back-cover and antenna assembly
To Next Page
Loading...
Need help?
General
