Removing the camera
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1. Remove the base cover.
2. Remove the battery.
3. Remove the wireless card.
4. Remove the display assembly.
5. Follow the procedure from step 1 to step 3 in "Removing the display back-cover and antenna assembly".
Procedure
1. Using a plastic scribe, pry up the camera module and turn it over.
2. Peel off the tape that secures the camera cable to the camera module and disconnect the camera cable from the camera
module.
3. Lift the camera module off the display panel.
36
64 Removing the camera
To Next Page
Loading...
Need help?
General
